This command specifies the action or sequence of commands to execute when the file is exited with the G or GO command. The sequence starts with the first command following the equals sign, and continues until the $ is encountered. The special character % may be used to refer to the name of the file being edited (without any extension) while the @ character refers to the file’s extension.
Under the standalone implementation of VUE, the GO command must be limited to a single line (e.g. GO=compil %$)
Example
This example consists of four consecutive lines in INI.VUE, shown below with explanations.
Line in INI.VUE |
Effect |
---|---|
GO = COMPIL %/M/X:2/LF/PX |
COMPIL the file using COMPIL switches M, X:2, LF and PX ("COMPIL TEST1.BAS/M/X:2/LF/PX") |
VERSYS %.RUN |
Display version information for the new file TEST1.RUN |
COPY RUNS:=%.RUN |
Copy TEST1.RUN to the RUNS: ersatz directory |
$ |
Done with GO command sequence |