Verifying the Installation

You will need to reboot to test the installation. If you followed the recommended procedure of working with a backup of AMOSxx.INI, use the MONTST command to reboot using the modified version of the INI file.

Verify that the system boots properly, and that the INMEMO.SYS (and any other lock modules) were loaded. You can use the SYSTEM command after system is booted to see the modules that were loaded into system memory. Also check for any scrap buffer modules (<job>.INF or INFBUF.BUF) and any function key translation tables.

If it didn't work, retrace your steps and try again. If still unsuccessful, contact your dealer or MicroSabio for assistance. If it works fine, then proceed to copy the new INI file back to AMOSL.INI.