1

Value will be set to 1 if the cell indicated by XTR.XROW and XTR.XCOL needs validation. Previously you had to rely on exitcode -48 to identify when validation was needed, but this is not adequate when the event which terminates an editable cell operation is a click on another control that generates its own exitcode. In that case, the exitcode returned to the application will be that of the clicked-on control, and the XTR.XVALIDATE flag will be handy to indicate that the cell identified by XTR.XROW and XTR.XCOL needs to be validated.

2

In some cases, the cell which needs to be validated is not the one that last had the focus, i.e. the one referenced by XTR.XROW / XTR.XCOL, but the one which gets the focus, i.e. XTR.TARGETROW / XTR.TARGETCOL. This is often the case with checkboxes, which exit for validation only when checked, and is always the case with read-only editable cells, which exit for validation just before they get the focus. In these cases, XTR.XVALIDATE will be set to 2.

3

This could have two possible meanings, depending on the context. One possibility occurs when clicking out of a cell that requires post-validation and into a cell that requires pre-validation or validation-on-click, in which case it means that both the XTR.XROW / XTR.XCOL and XTR.TARGETROW / XTR.TARGETCOL cells need validation. The other possibility is that the user selected the $CBSET, $CBRST, or $CBUNDO command from a PopupMenu to set, reset, or undo the state of all the checkboxes in the current column.

4

Indicates that the user clicked on a $CBSETDEP or $CBRSTDEP PopupMenu command to set or reset the dependent checkboxes for the current item.

5

In an editable tree without validation, a value of 5 indicates that at least one cell was changed during the session.