1546.5.2

SYSTAT.LIT 3.2(178) refinement (UNIX): Reduce the excessive ITC error messages (one per job) to just one overall when the /W mode is unable to send ITC messages due to privilege issues. Allow clean exit with Q or ESC from paging mode.

1543.0.7

SET.LIT 1.2(161) now supports setting/display language: SET LANGUAGE {lang}. If lang is not specified, it displays the name of the current language. Otherwise if tries to load the specified language file, interpreting lang as the LDF file name in the same way that MX_LANGUAGE does. Thus, while SET LANGUAGE may return "SPANISH", to set the language to Spanish you may need to use SET LANGUAGE SPANSH, assuming the LDF file name is DSK0:SPANSH.LDF[1,6].

1543.0.3

Add new LIT commands MUSER and LOGON.

1542.0.12

SORT.LIT 1.1(106) now supports localization; see LITMSG.xxx 056,### for message customization. Also, the display has been updated to show the number of records sorted.

1542.0.11

KILL.LIT 2.2B(125) now supports localization; see LITMSG.xxx 039,### for message customization.

1542.0.4

SHLEXC.LIT 1.0(103) enhanced (using XSHLEX.SBX, which see above) so that it now works in server environments with ATE or ZTERM clients, auto-transferring the file to the client if necessary. Requires XSHLEX.SBX and ATEAPX.SBX in BAS:

1540.0.2

SYSTAT.LIT 3.2(175) will display the group each job is assigned to, if applicable, with the /CU switch.

1534.2.4

HOST.LIT 2.0(106): : reduce minimum partition memory requirement from about 265K to 3K and increase the maximum output capture buffer size (when using /O) from 256K to 512K. Note that the total memory requirement when using /O has actually increased rather than decreased, but it is only required when using /O and in that case it is dynamically allocated outside the memory partition.

1534.2.3

QUTL.LIT 3.1(129): remove previous maximum of 20000 FLOCK or XLOCK records and reduce the fixed partition memory requirement from approximately 700K to 200K by using dynamic arrays.

1534.2.2

New DIR Switch MEMREQ displays the memory required for static variable storage.

1531.0.2

New SET.LIT 1.2 Flags DLL, ALL, and ATE.

1531.0.5

ZTXFER.LIT 1.4(108) now supports /ATE switch to force alternative transfer protocol—i.e. using ATE terminal channel. This was already automatic for transfers between an ATE client and a Windows server, but now can be forced in other situations. For example, under UNIX, FTP/SFTP transfers may be blocked by some security or other obstacle, while the ATE terminal channel would work.

1529.0.4

Add new LIT file WEBRUN.LIT

1529.0.2

Add support to SET.LIT for WEBCACHE.

1526.0.2

SET.LIT 1.2(156) updated to support TRACE flags JOBLCK and EXEC, which were added in 6.3.1518.0.

1515.0.3

LOG.LIT 3.0(124) now explicitly reports failure to log to directory.

1511.0.1

VUE 3.2(370) now uses the above technique to disable AutoMouse on the ATE client during the VUE session, then restores the prior settings on exit. Previously, this only occurred for A-Shell/Windows local mode. Note that if the ATE version is prior to 6.3.1511.0, AutoMouse will get disabled on entry into VUE, but not restored on exit.

1506.1.1

LICENS: Support new 6.3 PIC code format (XXXXXXX-XXXXXX-XXXXXX-XXXXXXX). The new PIC format is needed for certain extensions added in 6.3; it provides no benefits to 6.2 but is hereby supported just as a backwards capability convenience.