TAB(-1,23); |
! enable alternate character set |
TAB(-1,code); TAB(-1,code); |
! output alternate characters |
TAB(-1,24); |
! disable alternate character set (back to normal mode) |
As shown in syntax lines above, line draw / alternate character mode must be enabled with TCRT code 23 prior to executing the following codes and, after using these codes, disabled with TCRT code 24.
Code |
Action |
|
Code |
Action |
---|---|---|---|---|
38 |
Top left corner |
|
46 |
Horizontal line |
39 |
Top right corner |
|
47 |
Vertical line |
40 |
Bottom left corner |
|
48 |
Intersection |
41 |
Bottom right corner |
|
49 |
Solid block |
42 |
Top intersection |
|
50 |
Cross-hatch block |
43 |
Right intersection |
|
51 |
Slanted cross-hatch block |
44 |
Left intersection |
|
52 |
Double horizontal line* |
45 |
Bottom intersection |
|
53 |
Double vertical line* |
* Note that double lines are only supported when using the OEM character set; the more typical ANSI character set doesn't support them.
Example
! draw a box from srow,scol to erow,ecol
? tab(-1,23); ! enable alternate character set
? tab(srow,scol); tab(-1,38); ! top left corner
? tab(srow,ecol); tab(-1,39); ! top right corner
? tab(erow,scol); tab(-1,40); ! bottom left corner
? tab(erow,ecol); tab(-1,41); ! bottom right corner
for c = scol+1 to ecol-1
? tab(srow,c);tab(-1,46); ! top line
? tab(erow,c);tab(-1,46); ! bottom line
next c
for r = srow+1 to erow-1
? tab(r,scol);tab(-1,47); ! left side
? tab(r,ecol);tab(-1,47); ! right side
next r
? tab(-1,24); ! back to normal character set
See Also